
There are ways to share your previously ordered or your current PCB Builder/DKRed designs. This blog will show you how.

When you need to reorder your previously ordered PCB originally obtained through DigiKey’s PCB Builder or DKRed, this blog will show you how.

This webinar discusses connector solutions that meet or exceed VITA/VPX and ANSI standards for component interconnect.

Warehouse efficiency requires robust communication networks and devices to ensure smooth flow of data from order taking, automated fulfillment, and shipping.

A webinar discussing sound pressure level, power, and impedance along with resonance, frequency range, and other often-over-looked speaker selection qualities.

Accelerate the design of Amazon Sidewalk products with the Silicon Labs Pro Kit and take advantage of free community wireless networks.

Using sensor fusion, designers can combine voltage, current, and temperature sensors in BMSs to extend battery lifetimes and enhance performance.

enterprise data center, communications infrastructure, server, storage, networking equipment, card edge connector, cable connector, pulse amplitude modulation 4-level, PAM4

Implementing High-Performance Programmable Clock Generators

While LEDs can be used to indicate AC power is on, the classic neon lamp may offer a cost-effective and better technical alternative in many cases.

LiDAR for automotive applications relies on advanced ToF measurement capability that can be achieved with the right front-end TIA and comparator.

By using low dropout linear regulators (LDOs) with low Iq designers can extend battery life in wearables.

Readily available development kits for professionals and makers alike provide all the necessary hardware and software, greatly simplifying prototyping.

Antennas and their leads can do more than just handle RF: They can also carry DC power to a front-end amplifier or provide audio signals to user headphones.
There are many ways to modify the widely used whip (monopole) antenna for use at frequencies where its optimum quarter-wavelength size would be too long.
The new INA228 digital power monitor solution from Texas Instruments allowed me to measure current down into the nanoamp range for my updated BattLab-One.
There are several programming languages for PLCs that have been standardized in the IEC 61131-3 standard.
A safety PLC is a dedicated controller built and certified to meet safety requirements such as functional safety directives IEC 62061, ISO 13849-1 or IEC 61508.