文章和部落格

透過 LED 照明，NASA 已瞭解如何讓太空食物變得更加可口。

本文說明明尼蘇達大學與 DigiKey 如何攜手合作，快速推出適用於 COVID-19 病患的大眾市場呼吸器。

TDK-Lambda 的 PFH500 電源模組可滿足嚴苛環境下的工業設計標準。

瞭解並使用 IO-Link，以高效、經濟實惠的方式，在 IIoT 應用中部署智慧型感測器及致動器並進行通訊。

將感測器加至無人機時，需要謹慎地平衡功耗、功能及成本因素。本文會介紹一些合適的選項。

在備份 AI 型電源系統時，設計人員可以選擇電源供應器 PoL 中的 MPPT、遠端感測器監控模組以及 GaN 電晶體作為備份選項，以防萬一。

Almost three decades ago, the "brick" DC/DC converter power module was developed, which eventually led to the distributed power architecture (DPA) becoming the de facto standard for point of load (POL) designs.

Home energy systems based on renewable sources, such as solar and wind power, are becoming more popular among consumers and will gain increasing support from governmental bodies.

Flow sensors are used to measure flow velocity, volumetric flow rate, or mass flow of a liquid or gas. Mass flow for gases is specified in units of standard liters per minute (slm) or standard cubic centimeters per minute (sccm).

What once was a straightforward act of transforming an AC waveform into a DC source to power downstream devices is now greatly affected and driven by the power grid to maximize its available power.

Powerline filters protect expensive circuitry from potentially damaging power surges, as well as protecting the AC line from excessive noise conducted back into it from a noisy power converter.

Modular, high-density POL (point-of-load) power DC/DC converters have some excellent advantages over other power management architectures.

DC/DC converters are a great high-frequency noise source. Designers must take careful steps to minimize and contain this noise near and around the converter to keep it from affecting other system components or the AC mains.

Battery size constraints in energy harvesting systems necessitate creativity and innovation in order to maximize efficiency of the power source.

Ambient light sensor (ALS) products are quickly becoming one of the most effective solutions for power management and display quality enhancement in electronic products and systems.

As newer applications and systems tend to have multiple voltages to power DSPs, µCs, FPGAs, and ASICs, modern power supply designs must be able to control how and when these voltages ramp to their final values after the power switch is activated.

Relative humidity (RH) is defined as the ratio of the partial pressure of water vapor (in a gaseous mixture of air and water vapor) to the saturated vapor pressure of water at a given temperature.

Designers using modular power converters for their systems know how critical a thermal derating curve is to the success of their design.

Need a temperature sensor for your next application? You'll first need to sort through the three-letter acronyms before arriving at any BOMs.

A gas detection sensor’s function is to measure the concentration of gases. These devices have different methods to convert the gas detection element’s output to voltage.